View source for Dell MD3460

= Dell Management Software =

Installed on louvre by executing the .bin autoextracting script, and converting the rpms to tarballs with alien.

Had to modify the SMcli script to run /bin/bash instead of /bin/sh, and to set the BASEDIR directory.

SMcli documentation : http://downloads.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_powervault/powervault-md3000_Reference%20Guide3_en-us.pdf

= Array configuration =

Three disk groups of 20 disks each in RAID 6 (2 parity disks per 20 disks).

Each disk group contains one Virtual Disk of full capacity.

Each Virtual Disk is mapped to Louvre with a LUN number (VD 0 -> LUN 1, VD 1 -> LUN 2, VD 2 -> LUN 3).

= Host configuration =

== Multipath ==

We have two redundant SAS paths to the storage array. To handle those redundant paths, we installed multipath-tools. multipath-tools autodetects the redundant paths and configures one device per virtual disk in /dev/mapper/<wwn> (where <wwn> is the world-wide number of the virtual disk, which can be displayed using the "show virtualDisk ["foo"];" command in SMcli.

== RAID 0 ==

We configure a RAID0 over the three virtual disks, with mdadm: mdadm --create --level 0 /dev/md0 /dev/mapper/3600a09800068becb0000025*

== LVM ==

pvcreate /dev/md0
vgcreate vg-data /dev/md0

== Filesystems ==

for i in 0 1 2 3 4 5 6 7 8 9 a b c d e f; do lvcreate -L 4000000 -n $i vg-data; mkfs.xfs /dev/vg-data/$i; done



[[Category:System administration]]